Zagg Instructions
- 1). Fold a series of microfiber towels and place them on top of each other on a work surface as padding for the phone. Clean off the device with another microfiber towel. Wash your hands thoroughly with soap.
- 2). Place the phone face down on the towel. Pull the main portion of the ZaggSkin off the backing pad with your hands. Align the camera hole on the ZaggSkin with the camera on the phone. Set it in place and verify proper alignment with the camera hole and the volume buttons on the sides of the phone.
- 3). Run the included installation cloth down the center of the ZaggSkin to remove any bubbles from the decal. Work the cloth across the back of the decal, from the center out, but do not push down the side pieces yet. Stop when there are no bubbles on the back of the decal.
- 4). Position the decal properly on the volume control buttons. Peel back the ZaggSkin slightly on the side so that the decal is level with the back of the device. Roll your thumb from the back of the device down the middle of the side panel. Continue that motion working from the center of the side panel up to the top and bottom of the phone, working out air bubbles with your thumb. Repeat on the other side of the phone.
- 5). Determine which of the two remaining pieces is the top of the skin and which is the bottom by looking for headphone holes and button slots. Pull off the top piece from the backing pad with the tweezers. Align the straight edge of the top piece with the front of the phone, then set it in place. Push the decal down with your thumb, working from the center out to the sides. Repeat for the bottom and final decal in the kit.
