Common Issues

• 1). Press the "On" button of the remote control to turn the water heater on if there is no hot water. Make sure the hot water faucet is open fully. Turn the water shutoff valve to open it completely.
  
  
• 2). Increase the temperature on the water heater if there is not enough hot water. Ensure the hot and cold water lines are installed correctly. Reverse them, if needed.
  
  
• 3). Turn the gas valve to open it fully if the water is not hot enough.
  
  
• 4). Decrease the temperature on the water heater if the water is too hot. Open the water shutoff valve fully.
  
  

Error Codes

• 1). Turn off the hot water faucet if an error code is displayed on the remote control. Press the "Off" button of the remote to turn off the water heater. Wait five minutes. Turn on the hot water faucet and press the "On" button of the remote. If the error code is still displayed, turn off the faucet, press the "Off" button on the remote and continue to the next step.
  
  
• 2). Open the gas shutoff valve completely if "11" is displayed on the remote control.
  
  
• 3). Refill the LP gas container or replace it with a new cylinder when "12" is displayed on the remote control. If you don't have an LP model, contact your utility company. This code indicates that the supply of gas has been interrupted.
  
  
• 4). Open the hot water faucet completely if "15" is displayed on the remote control. This means there is not enough water volume to trigger the heater to heat the water.
  
  
• 5). Remove any obstructions on the air intake or vent termination if "05" displays on the remote control. This indicates that the air intake is blocked.