How to Repair a Cut Power Cord
- 1). Cut 2 inches of sheathing from both cut ends of the cut power cord with a utility knife. Measure the total length of insulation that you removed and slide an appropriate length of heat-shrink tubing onto one of the sections of cord and slide the tubing out of the way.
- 2). Separate the wires inside the sheathing and remove 1/2 inch of insulation from the ends of all the wires with a wire splicing tool. Slide a length of heat-shrink tubing onto one half of each of the black, white and green wires. This tubing should be long enough to cover the splice when you are done. Use a smaller diameter tubing than the one you used for the power cord itself.
- 3). Join the black wires. If the wires are multi-strand, you can twist them together with pliers and bend the twisted wires down. If you have a soldering iron, a more effective way to join them is by soldering them with electrical solder. Use a crimp lug for single-strand wire. Insert the ends of the black wires into opposite ends of the lug and squeeze the ends of the lug with pliers to crimp the wires and hold them securely.
- 4). Slide the heat-shrink tubing over the repair and hold the flame of a cigarette lighter close until the tubing shrinks. Don't let the flame contact the tubing or it may melt.
- 5). Repeat steps 3 and 4 with the white and green wires.
- 6). Slide the larger diameter tubing along the power cord until it covers the repair and then shrink it with a lighter.
