Introduction: Wireless gas leakage detector is suitable for home, gas station, to detect natural gas, coal gas and petroleum gas, etc.
When the gas concentration reaches the dangerous level, it will send visual and audible alarming signals to your alarm system.
Installation: 1.
First step is to measure the proportion of fuel gas and air, and then fix the detector on the right place within 1.
5m distant from the radius of the gas source: A.
Coal gas: lighter than air, floating on high.
B.
Natural gas: lighter than air, floating on high.
C.
Liquefied petroleum gas: heavier than air, deposit on low.
2.
Power on the detector, you will hear a "beep" sound.
At the same time power indicator is normally open; functional indicator flashes in green color (go out about 2 minutes later), which indicates entering the status of alert.
When there is gas leakage, the detector will send out "beep" sounds; meanwhile, functional indicator will flash in red color.
Detector enters into alert status automatically after alarm elimination.
3.
If the sensor fails to work, the detector will send out long "beep" sound, functional indicator will normally light in yellow color.
Detector enters into alert status automatically after fault resolution.
Note: Do not install the detector outsides.
Do not install the detector in the place of strong air velocity, such as gas outlet, ventilator, doors, etc.
Do not install the detector in high-temperature ( 10-50F ) or damp environment.
Do not install the detector in the place where the detector and gas equipment are blocked by other objects.
Avoid to largely use solid hair spray, pesticides, paint adhesive, diluted alcohol and so on near the detector.
If the detector fails to work, do not laid-up by yourself, call the supplier or the nearest agency.