How to Fix a Loose Small Belt on the Hoover Self-Propelled WindTunnel
- 1). Set the brush roll control on the base of your Hoover Self-Propelled WindTunnel to “Hard.”
- 2). Step on the handle release pedal at the rear of vacuum and lower the handle to the ground.
- 3). Turn the Hoover vacuum over, revealing the brush roll inside the cleaning head.
- 4). Remove the four screws from the plate covering the brush roll. Place the screws in a cup to prevent losing them.
- 5). Remove the plate.
- 6). Lift up on the belt side of the brush roll to free the roll from the cleaner head. Slide the small belt off the side of the brush roll.
- 7). Position the small belt over the groove beside the pulley at the rear of the belt. Pull up on the belt to “snap” it into the groove.
- 8). Slide the front end of the belt back over the brush bar. Position the belt in the groove on the brush bar.
- 9). Fit the end of the brush bar back into the cleaner head.
- 10
Place the plate back over the brush bar. Thread the screws in place by hand, then tighten them using the screwdriver.
