Set Up the Tuner

• 1). Connect one end of a coaxial cable to the "Transmitter" port on the back of the tuner. Connect the other end of the cable to an amplifier or transmitter.
  
  
• 2). Connect the end of the coaxial cable from the antenna to coax connector "1" that is on the rear of the tuner. If you have a random wire antenna, it will need to be connected to the "Wire" port on the rear of the tuner.
  
  
• 3). Plug the power cable for the tuner into a wall outlet or a power strip.
  
  
• 4). Press the "Power" button to turn on the tuner.
  
  

Operate the Tuner

• 1). Turn the "Antenna Selector" knob to "Antenna 1" and set the control knob for the antenna and transmitter to "4."
  
  
• 2). Set the position of the "Inductor" knob to the lowest setting. Turn the knob counterclockwise or to the left to increase the inductance of the tuner.
  
  
• 3). Place the "Power" switch to the "LO" or "AVG." This will transmit a low power signal between 10 to 50 watts.
  
  
• 4). Turn the control knob for the "Antenna" and "Transmitter" to the minimum setting.
  
  
• 5). Power on the transmitter or amplifier and tune them to the recommended settings.